What are the ways to install solar aluminum support

For different conditions of solar aluminum support,choose reasonable connection form,and strive to design to achieve:applicable,economic,reasonable,beautiful,to adapt to and reflect the requirements of modern industrial civilization production,at the same time as much as possible to reduce the project cost,so that limited investment to form production capacity as soon as possible,to obtain economic benefits.

Bracket installation:place the anchor bolt holes of the front and rear columns on the anchor bolts on the concrete foundation that has been completed;Check whether the front and rear columns are correct;The center line in the direction of the length of the front and rear columns coincides with the center line of the pillar(the axis of the concrete foundation).Measure the leveler or horizontal pipe to measure the levelness of the front and rear columns,and adjust the perpendicularity of the column with a vertical ball.If the elevation of pile foundation surface is deviated,flatten the front and rear columns with a cushion block and then tighten the anchor bolts.The pad is welded to the base of the front and rear column feet.Check bracket bottom flatness and diagonal errors.After adjusting the beam error within the specified range,tighten the bolts with a wrench.

Beam installation:determine the position of the beam according to the spacing and end length required by the design.Tighten the bolts of the beam to achieve horizontal,flat and vertical connection.In order to fix the square of the panel on the beam,should be in advance on the beam square,diagonal measurement adjustment,diagonal deviation in the allowed range of deviation.After installation of the column diagonal tie rod,the column diagonal tie rod and fastening the tie bolt make all components of the solar aluminum support bear uniform force.